https://devzone.nordicsemi.com/f/nordic-q-a/1002/setting-up-arm-gcc-and-nordic-sdkI am beginner on this platform. I was hoping for KEIl IDE to aid my development, but since license fee is more, i wanted to try GCC platform. But unable to set it up. In nAN-29 pdf, chapter 2 document there is a step 6. Select the _build\ble_hrs_gcc_s110_xxaaen-USTelligent Community 13Wed, 27 Nov 2013 11:45:03 GMThttps://devzone.nordicsemi.com/thread/4737?ContentTypeID=1Wed, 27 Nov 2013 11:45:03 GMT137ad170-7792-4731-bb38-c0d22fbe4515:a6a9f63c-84d2-472f-a952-42212b36a5a5Ole Morten<p>As KPE correctly states above, this file will only be there once you have successfully compiled your project.</p> <p>I&#39;ve often found it easiest to get compiling to work from the command line first, and only after that getting Eclipse to work. Do you get any errors when running make from a command line shell inside the gcc subfolder of the project?</p><div style="clear:both;"></div>https://devzone.nordicsemi.com/thread/4736?ContentTypeID=1Tue, 26 Nov 2013 23:30:06 GMT137ad170-7792-4731-bb38-c0d22fbe4515:2a468035-351f-42ae-a7c7-e6f80275e8c8KPE<p>I suppose you would need a successful build (compile+linking without errors), before both the folder and .out (binary) file are produced.</p> <p>There is a some work involved with getting Eclipse+GCC to work, but once you have invested the time I can assure that you are going to like it. I have tried both platforms, and though Keil is a lot easier to get working, I think Eclipse+GCC is the better choice in the long run. So go ahead and see if you can figure the problems one by one. Troubleshooting will teach you a lot of how the Eclipse+GCC setup is working - it did for me.</p><div style="clear:both;"></div>