IAR + Debugging won't hit main

RE: IAR + Debugging won't hit main

hadirobati — Wed, 20 Nov 2019 07:23:14 GMT

Go Project Options->C/C++ Compiler->Output and Check 'Generate output information'

Ryan T — Wed, 04 Nov 2015 19:30:04 GMT

I found the problem...

when it was downloaded I clicked "No" when J-link asked if I wanted to pick the specific ARM device.

Note to everyone else... make sure you say yes and select the proper Nordic Part or else it won't work!

-Ryan

Ryan T — Wed, 04 Nov 2015 14:56:21 GMT

those were already set, no luck...

Alex — Wed, 04 Nov 2015 14:53:43 GMT

In Project Options - Debugger->Setup enable Run to main. In Debugger->Extra Options enable Use command line and add --drv_vector_table_base=0x0