Get data from ISP1907-AOA-DK

RE: Get data from ISP1907-AOA-DK

Simonr — Fri, 01 Sep 2023 09:17:09 GMT

Hi again Marvin

You'll need to create a board file for the nRF52833 board you're using that uses the correct pins for I.E. antenna switching, etc. The antenna matrix config should be the same for the ISP AOA antenna array as what is already configured in the sample. You can check out our documentation page on custom board configuration here. Hope that helps.

Best regards,

Simon

RE: Get data from ISP1907-AOA-DK

Marmako — Thu, 31 Aug 2023 14:12:45 GMT

So I went through the project you recommended to me. Unfortunately I'm unable to flash my board cause the device is not detected in the VS Code extension. Can you by any chance give me some hints on how to achieve this? I've figured out that the hardware used on the board utilizes a nRF52833-Chip. So I edited the build config (see picture below) and I also checked that all needed software is up-to-date.
I've also contacted Insight SIP if they can provide further information on that topic.

Best regards,

Marvin

RE: Get data from ISP1907-AOA-DK

Marmako — Tue, 29 Aug 2023 12:26:17 GMT

Thank you very much. I will have a look at the project.

RE: Get data from ISP1907-AOA-DK

Simonr — Tue, 29 Aug 2023 11:44:06 GMT

The Direction Viewer firmware is just for demo purposes, and we don't provide the source code for it I'm afraid, so if you'd like to create a Python plot on your end that's up to you, but I'd recommend using the Connectionless Direction Viewer locator sample project as a template for the AOA DK's firmware, and modify it to output the data you need in your Python script over UART for example that can be printed in a terminal on your computer for example.

Best regards,

Simon