nRF52840 DK as debugger

RE: nRF52840 DK as debugger

Maria Gilje — Wed, 08 Nov 2023 10:12:15 GMT

Hello,

I had to forward this question internally. Their answers are below.

[quote user="Vikas Bhatt"]What is the purpose of R69 (866R) at the P20 debug connector in PCA10056 Schematic (nRF52840 DK reference schematic)? [/quote]

Pin13 / R69 can be used by a plug-in board to detect what kind of DK it is connected to. This is not currently used by any publicly available boards from Nordic.

[quote user="Vikas Bhatt"]Is it possible to directly connect pin 13 with the ground of the P20 connector, thereby removing the connection between R69 and pin 13?[/quote]

If GND is wanted you could replace with 0R resistor or short the pads of R69.

Best regards,

Maria

RE: nRF52840 DK as debugger

Vikas Bhatt — Mon, 06 Nov 2023 04:54:13 GMT

What is the purpose of R69 (866R) at the P20 debug connector in PCA10056 Schematic (nRF52840 DK reference schematic)?

Is it possible to directly connect pin 13 with the ground of the P20 connector, thereby removing the connection between R69 and pin 13?

RE: nRF52840 DK as debugger

Maria Gilje — Fri, 03 Nov 2023 07:39:05 GMT

Hello,

[quote user=""]If we want to use the nRF52840 DK (3.0.1) as a debugger, how can we do that?[/quote]

We have a user guide on Debug output in the Infocenter which you can follow. The instructions are the same for any version of the nRF52840 DK.

Best regards,

Maria