nrf master tool cant display list of my personnal services after programming the bootlader region

RE: nrf master tool cant display list of my personnal services after programming the bootlader region

makouda — Thu, 03 Dec 2015 08:52:09 GMT

according to FAQ :

If there is no bootloader address, MBR will forward interrupt to softdevice and jump to first address after softdevice (application). I used mergehex command to merge sofdevice and my program, but then I got the same probem (cant see my services)

RE: nrf master tool cant display list of my personnal services after programming the bootlader region

Vidar Berg — Wed, 02 Dec 2015 12:43:14 GMT

It's the location where bootloader settings are stored in flash. Please refer to the FAQ I linked to for more details.

RE: nrf master tool cant display list of my personnal services after programming the bootlader region

makouda — Wed, 02 Dec 2015 12:41:27 GMT

what deoes 0x3FC00 address mean.???

RE: nrf master tool cant display list of my personnal services after programming the bootlader region

Vidar Berg — Wed, 02 Dec 2015 12:02:18 GMT

It's actually the bootlaoder that it's advertising its DFU service if I'm not mistaken. Try setting the app valid flag in the bootloader using nrfjprog:

nrfjprog --memwr 0x3FC00 --val 1
nrfjprog -r

Then check the ATT table again.

RE: nrf master tool cant display list of my personnal services after programming the bootlader region

makouda — Wed, 02 Dec 2015 11:58:59 GMT

But is the advertising is working and I can connect and see general attributes(which is my case), is that mean that the application is runnung

RE: nrf master tool cant display list of my personnal services after programming the bootlader region

Vidar Berg — Wed, 02 Dec 2015 11:34:51 GMT

The bootloader will always be executed before the application when programmed (MBR reset behavior), but it won't "jump" to the application before it knows that there is an valid application present. See question 'E' in this FAQ for more details.