I want to receive RX signal by using Device Test Mode application with nRF5340.

RE: I want to receive RX signal by using Device Test Mode application with nRF5340.

Jared — Mon, 29 Jan 2024 10:22:30 GMT

Hi there,

You need a Tester to perform DTM, if you don't have another development kit that you can use as a tester, then you have to use a Anritsu.

regards

Jared

RE: I want to receive RX signal by using Device Test Mode application with nRF5340.

Daniel Lim — Mon, 29 Jan 2024 05:21:04 GMT

I want to clarify your answer.

Q1 : Can I do a receiver test with only one EVK board?

Q2: How can I set my board as DUT?

Thanks a lot

BRs

Daniel Lim

RE: I want to receive RX signal by using Device Test Mode application with nRF5340.

williseugene333 — Mon, 29 Jan 2024 01:33:56 GMT

The Device Under Test (DUT) can act as both a transmitter and a receiver in DTM. In DTM, the DUT generates test packets that are transmitted and received internally. This is a good way to verify the radio part of your device. vampire survivors