nRFgo Studio cann't update the firmware via UART

RE: nRFgo Studio cann't update the firmware via UART

Alice — Mon, 16 Dec 2013 10:41:55 GMT

Hi Hung Bui,

Is there any good news can be shared or could you give me some advice that I can try at the same time?Thanks

BR Alice

RE: nRFgo Studio cann't update the firmware via UART

Alice — Thu, 12 Dec 2013 08:07:25 GMT

Hi Hung Bui,

Thank you so much for your reply.
Yes,I do the setup on the 6310 as the image you attached.I do the test on Windows XP 32bit and we donn't have Windows 7.

Thank you for your test and I also try to find other machine to do the test.Thanks.

Look forward to your good news.

RE: nRFgo Studio cann't update the firmware via UART

Hung Bui — Wed, 11 Dec 2013 12:55:15 GMT

Hi Alice,

Have you verified you connected all four pin for UART on the nRF6310 properly ? You can refer to the attached image for the setup.

Your python error seems quite strange. On which machine and OS did you run the test ? We have only tested on Windows 7. Could you try on other machine ? You can try to uninstall Python for testing. The .exe doesn't require python to be installed.

Note that when the HCI bootloader running, LED2 should be lighted, not LED1.

I will try to make an example of using bootloader without softdevice and will havea an update when it is ready.