Connected Device showing, but its Details not showing in vs code

RE: Connected Device showing, but its Details not showing in vs code

Menon — Tue, 27 Feb 2024 13:47:07 GMT

Hello Akash,

I don't see an nRF device inside the device manager. Please make sure you have installed the nRF command-line tools properly.

If this has already been installed, please go through the steps mentioned on the below page:

https://wiki.segger.com/J-Link_shown_as_generic_BULK_device_in_Windows

Kind Regards,

Abhijith

RE: Connected Device showing, but its Details not showing in vs code

Akash_91 — Tue, 27 Feb 2024 05:15:51 GMT

I am attaching the device manager screenshot.

It's showing a USB Serial Device in COM6 and COM7. I have only connected one Device that is nRF7002DK in one port only.

I have tried recovering the device using nrfjprog --recover, but also shows an error, no Debuggers Were discovered.

I am a beginner, please guide me on what driver or software needed to install although I have installed everything mentioned in the steps I followed in installing.

RE: Connected Device showing, but its Details not showing in vs code

Menon — Mon, 26 Feb 2024 10:12:54 GMT

Hello,

Are you able to find your device inside the device manager (Device Manager->Ports and COMS->Jlink)? See the screenshot below:

Can you try recovering your device using nrfjprog --recover?

Take a look at this thread, which deals with a similar error.

Kind Regards,

Abhijith