Failed to communicate with nrf7002 custom board

RE: Failed to communicate with nrf7002 custom board

Sudhakar V — Fri, 03 May 2024 11:47:45 GMT

Hi kcl,

I am currently implementing the co-existence sample on the nRF52840dk with nRF7002ek, and I am encountering the same issue that you faced. Could you please advise me on how to resolve this issue?

Thanks and Regards,

Sudhakar V.

RE: Failed to communicate with nrf7002 custom board

kcl — Fri, 19 Apr 2024 04:21:18 GMT

I was able to resolve the issue on my own. Thank you for your support.

RE: Failed to communicate with nrf7002 custom board

kcl — Fri, 19 Apr 2024 01:33:33 GMT

By the way, I have a question regarding sending UART commands through SWD instead of UART. Currently, I can view the logs through SWD, but I'm unable to issue commands to initialize the nRF7002.

I would appreciate any guidance or suggestions on how to accomplish sending UART commands via SWD. Thank you.

RE: Failed to communicate with nrf7002 custom board

kcl — Fri, 19 Apr 2024 01:17:55 GMT

Thank you for your suggestion. I managed to resolve the issue, but interestingly, it wasn't by following the solution provided in the post. I found out that 'Clean Build Configuration' option in VS Code and rebuild the project doesn't sync my custom board settings.(In my case, I have changed my wifi pin configuration that why nRF52840 not able to communicate to nRF7002)

Instead, I had to 'Remove build configuration' and then create a new build configuration so nRF Connect SDK able to pick up my new board settings.

I just wanted to share this workaround in case others encounter a similar problem.

RE: Failed to communicate with nrf7002 custom board

Amanda Hsieh — Thu, 18 Apr 2024 14:06:26 GMT

Hi,

Check out this post.

Regards,
Amanda H.