Failure of GPIOTE configuration when multiple GPIOTEs are used in NRF Connect SDK

RE: Failure of GPIOTE configuration when multiple GPIOTEs are used in NRF Connect SDK

Naeem Maroof — Mon, 13 May 2024 15:29:33 GMT

Thank you for updating. Good to know that your issue is resolved.

Warm regards,

Naeem

RE: Failure of GPIOTE configuration when multiple GPIOTEs are used in NRF Connect SDK

mystic_harbor — Fri, 10 May 2024 20:16:51 GMT

Thank you for responding.

I was able to fix this issue by including the below line in prj.conf.

CONFIG_NRFX_GPIOTE_NUM_OF_EVT_HANDLERS=2

The different triggers were intentional and I had configured P0.25 and P0.27 for GPIOTEs. I think the problem was with allocating channels when multiple GPIOTEs were used. With the above line in prj.conf, it fixed the issue.

RE: Failure of GPIOTE configuration when multiple GPIOTEs are used in NRF Connect SDK

Naeem Maroof — Fri, 10 May 2024 14:34:24 GMT

Hi,

I will look into this ticket.

Can you provide me with the minimal version of your project that was working in nrf5 sdk and also the one which you have updated to in ncs that is not working?

Is the different tigger config intentional for pin1 and pin2?

which pins you are using for pin1 and pin2?

are handler functions the same?

Regards,
Naeem