DFU properly completed but Distribution phase changed to Failed

RE: DFU properly completed but Distribution phase changed to Failed

Elfving — Thu, 23 May 2024 12:34:02 GMT

I am glad you managed to solve it in the meantime. Thank you for your patience.

Regards,

Elfving

RE: DFU properly completed but Distribution phase changed to Failed

stefanogradozzi — Wed, 22 May 2024 10:09:56 GMT

HI,

in the meantime I luckily solved the problem.

At the end of the operation I didn' wait enough time to let the targets apply the updated firmware and reset themselves, so the Distributor failed to receive the final acknowledge from them.

I solved the issue increasing the number of retries, adding this line in prj.conf:

CONFIG_BT_MESH_BLOB_CLI_BLOCK_RETRIES = 12

Thank you for your availability

Bye

RE: DFU properly completed but Distribution phase changed to Failed

Elfving — Tue, 21 May 2024 14:54:55 GMT

Hello Stefano, and thanks for waiting. It's been a bit busy here.

Has there been any changes to your problem in the meantime? What NCS version are you using? Are these unmodified samples that you are running?

Could you try increasing the timeout value and see if that helps?

[quote user=""]

I also verified that new firmware was properly updated on Target

[/quote]

How are you verifying that it is correctly updated. Could it be that you are mistaken about this?

Regards,

Elfving