Peripheral_uart fails to build after editing build configuration

RE: Peripheral_uart fails to build after editing build configuration

runsiv — Wed, 21 Aug 2024 06:15:04 GMT

Thank you, I have asked internally if anyone has seen the same issue and know of a fix. I will update as soon as I have something
Regards
Runar

RE: Peripheral_uart fails to build after editing build configuration

Fisherdude — Tue, 20 Aug 2024 17:56:02 GMT

Hi Runar,

Correct. When I first add a build configuration to a new peripheral_uart application, I do not see any Extra CMake Arguments. The application builds just fine.

If I edit the build configuration, the extra CMake arguments are there, including the one with the prepended ".;", which causes the build failure. I replicated these steps just now, and the extra CMake arguments, including the one that causes the failure, are there.

You are also correct that if I remove the extra arguments, it builds correctly.

Rick

RE: Peripheral_uart fails to build after editing build configuration

runsiv — Tue, 20 Aug 2024 06:34:12 GMT

Hi Rick

I'm trying to replicate the issue at my end.

As of now I could not see anything while using the pre-release version of the extension

If I use the release version I see the extra build arguments gets added. However I do not experience any issue.

Just to verify. If you have a blank project you don't see anything. Then you build and it then you might see them? To me it looks like the extension picks up leftover build arguments from the build process which is added normally during the build process.

I would expect everything to work if you just remove the extra build arguments as they should not be needed to add manually. I will try to see if I get the system to fail at building.

Regards

Runar