Not Able to reach max ADC value (4200mV) in nrf5340

RE: Not Able to reach max ADC value (4200mV) in nrf5340

mark.blackburn.orpyx — Tue, 10 Sep 2024 14:52:20 GMT

Try putting in the filter capacitor (C37). Because of the high impedance of the resistor divider, the capacitance in the sample and hold circuit will cause the voltage to drop at the instant the sample is being taken.

Having the capacitor right at the ADC input gives it a "tank" of charge to draw from. The capacitor value needs to be large (100X) compared to the capitance in the sample and hold circuit. The larger it is the less error.

RE: Not Able to reach max ADC value (4200mV) in nrf5340

sasikumar p — Tue, 10 Sep 2024 14:11:13 GMT

I am using a voltage divider in my project to scale down the voltage before reading it with the ADC
i have share the voltage divider circuit.

I am experiencing an issue to reach the ADC Max value(4200mV) on the nRF5340(our custom board) with using voltage divider . We are using a 12-bit ADC, 4.2V and received a reading of 3297 adc, but we were expecting 4095 adc.

RE: Not Able to reach max ADC value (4200mV) in nrf5340

mark.blackburn.orpyx — Fri, 23 Aug 2024 13:27:35 GMT

You can't read a higher voltage on an ADC then what is used to power the processor (3.3V).

If you need to read a higher voltage, you typically have to use a voltage divider using resistors scale the voltage down and do the math in the processor to turn it into the equivalent voltage.