CMakePresets.json: how to select board/target and enable sysbuild

RE: CMakePresets.json: how to select board/target and enable sysbuild

Sigurd Hellesvik — Fri, 03 Jan 2025 09:24:53 GMT

Devs found and was able to fix the board detection from CMakePresets. The fix will be included in a future release.

RE: CMakePresets.json: how to select board/target and enable sysbuild

Sigurd Hellesvik — Fri, 03 Jan 2025 07:23:56 GMT

Missed that part. I see the same: No board file is used.

Will report this to devs as well.

RE: CMakePresets.json: how to select board/target and enable sysbuild

caeg — Thu, 02 Jan 2025 16:50:22 GMT

OK, thanks. What about the CMakePresets automatic selection of the board - it worked before I updated to hwmv2; have I made a mistake in that?

RE: CMakePresets.json: how to select board/target and enable sysbuild

Sigurd Hellesvik — Thu, 02 Jan 2025 08:50:03 GMT

Devs say that Sysbuild configuration in CMakePresets.json is not supported yet. We are not able to give any estimates for potential support of this.

RE: CMakePresets.json: how to select board/target and enable sysbuild

Sigurd Hellesvik — Mon, 30 Dec 2024 13:49:17 GMT

Hi Greg,

[quote user=""]The secondary request is this: is there a way for my CMakePresets to change the "System build (sysbuild)" selection from its default ("Build system default") to "Use sysbuild"? [/quote]

I suspect the answer is that sysbuild is not enabled/disabled by cmake => no.

But I will run that by our sysbuild expert and let you know what the answer is.

Regards,
Sigurd Hellesvik