Differing behavior between DKs when running sid_end_device sample

RE: Differing behavior between DKs when running sid_end_device sample

runsiv — Fri, 31 Jan 2025 10:03:00 GMT

That sounds great. I hope it will not be the case but if it happens again please make a ticket

Regards

Runar

RE: Differing behavior between DKs when running sid_end_device sample

mbprx — Wed, 29 Jan 2025 16:52:59 GMT

Hey Runar,

I thought that as well, but ran into the same trouble with a different provisioning file. Nothing I've tried has successfully returned the sample back into working condition. Everything seems to be normal, except that it won't register any more after the board configurator step. Our sales rep sent us two more DKs, so I may see if I can replicate it with more explicit & traceable steps. If I do, I'll open a separate ticket.

Thanks,

Miles

RE: Differing behavior between DKs when running sid_end_device sample

runsiv — Fri, 24 Jan 2025 09:21:58 GMT

Hi and sorry for the delay

I could not get any good explanation for what was the issue with the board on question. The only thing I can think (and this is just speculation on my end) is that the same provision file was used for two devices at the same time. But this would not however explain why it worked on the next 54l15.

Regards

Runar

RE: Differing behavior between DKs when running sid_end_device sample

mbprx — Tue, 14 Jan 2025 16:49:45 GMT

Hi Runar,

Just checking back -- any word from the sidewalk team?

RE: Differing behavior between DKs when running sid_end_device sample

runsiv — Wed, 08 Jan 2025 06:03:47 GMT

Hi Miles, I will check inn with our sidewalk team and get back to you. I see the setup do not say anything regerdaging PDK/DK V0.8.1 or higher so I need to check if there is anything specific there.

Regards

Runar

RE: Differing behavior between DKs when running sid_end_device sample

mbprx — Wed, 08 Jan 2025 00:35:32 GMT

I was reviewing my process, and realized that with the second PDK that I'd skipped the Semtech SX1262 setup for PDK revision v0.3.0 / v0.7.0 (my PDKs are 0.8.1, so not sure which process I should have used here).

I went through this board configurator process for my second, functional PDK and now it is also non-functional. Reverting to the default settings on the board configurator does not seem to fix it either :(