Question: USAGE FAULT Occurring in Zigbee

RE: Question: USAGE FAULT Occurring in Zigbee

Kenta — Wed, 15 Jan 2025 07:57:09 GMT

Hello Maria.

After updating the Zigbee add-on for the nRF Connect SDK to version 0.3.1, the USAGE FAULT no longer occurs, so this issue has been resolved.
Thank you very much.

Best regards.

RE: Question: USAGE FAULT Occurring in Zigbee

Maria Gilje — Fri, 10 Jan 2025 13:42:40 GMT

Enjoy your vacation!

RE: Question: USAGE FAULT Occurring in Zigbee

Kenta — Fri, 10 Jan 2025 13:12:22 GMT

Hi Maria.
Thank you for your support.

I'm going on vacation for 3 days starting tomorrow.

I'll try on Tuesday and be able to upload the .pcap file.

Best regards.

RE: Question: USAGE FAULT Occurring in Zigbee

Maria Gilje — Fri, 10 Jan 2025 12:56:52 GMT

Hi Kenta,

This seems to need some additional investigation and information.

If you enable CONFIG_THREAD_NAME in your configuration file, the name for the "Current thread" will be logged if it has a name. The thread name can be a good indicator on where to debug the code.

Are you running one of our samples or your own application?

[quote user=""]When powering on the devices in the sequence of Coordinator -> Router -> End Device, a USAGE FAULT repeatedly occurs on the Coordinator.
However, when powering on the devices in the sequence of Coordinator -> End Device -> Router, the USAGE FAULT does not occur.[/quote]

Could you create a sniffer trace for these two scenarios? If you are not sure what to look for in the traces, you can share it as a .pcap file and I'll take a look. If you are using another network key than the default from nRF Connect SDK, please let me know so I can arrange for you to share it privately.

Best regards,

Maria