BLE measurements nRF54L15

RE: BLE measurements nRF54L15

Jørgen Holmefjord — Wed, 02 Apr 2025 14:51:15 GMT

[quote user="Hans Erik Gram"]So if I set it in DTM mode, I can do my receiver test ?[/quote]

Yes, but you need to program the nRF54L15 board with the DTM firmware firsts.

[quote user="Hans Erik Gram"]Do you know which IO pin on the nRF54L15-PDK bord which is UART?[/quote]

The nRF54L15 (P)DK has two virtual COM ports, available on the pins described in the DK user guide. By default, DTM uses Serial 1 available on P1.04 (TX) and P1.05 (RX).

[quote user="Hans Erik Gram"]As weel what is the baud rate?[/quote]

The default baudrate is 19200.

RE: BLE measurements nRF54L15

Hans Erik Gram — Wed, 02 Apr 2025 12:46:33 GMT

Hi Jørgen

Sorry for late reply. Yes I know the Receiver Tap.

So if I set it in DTM mode, I can do my receiver test ? Do you know which IO pin on the nRF54L15-PDK bord which is UART? As weel what is the baud rate?

Br Hans Erik

RE: BLE measurements nRF54L15

Jørgen Holmefjord — Mon, 10 Feb 2025 12:05:34 GMT

Hi Hans Erik,

To setup a receiver test in the DTM app in nRF Connect for Desktop, you need to go to the "RECEIVER" tab:

From there, you can configure the channel, PHY, etc. and start the test.

Best regards,
Jørgen