RE: BLE Antenna Issues on Custom nRF52840 PCB – Need Help!

Bendik Heiskel — Fri, 28 Feb 2025 14:38:36 GMT

Hi,

There are a couple of issues with the RF part of the layout:

The shut capacitor closes to the SoC must be grounded to only the VSS_PA pin and the center GND pad, and not to the main ground fill. Here is a snippet from the refrence desing showing the correct way to ground this capacitor:

This capacitor should also be moved closer to the SoC.
There is no ground under the RF trace, we recommend only having a cutout under RF path on the internal layers and keeping the bottom layer ground fill.
There are very few GND vias in the center GND pad, we recommend at least a 3x3 grid.

These issues will impact the RF performance, the output power will probably be lower and the spurious emissions will be higher. But it should still be possible to see the advertisements at a short range.

The onboard antenna will probably need to be tuned. The antenna datasheet recommend only one shunt capacitor, but from my experience with this antenna a full Pi network should be used instead.

What is the load capacitance on the crystals?

Based on the part numbers the 32MHz crystal needs 20pF capacitors and the 32.768kHz 4pF.

These numbers are based on the following equation:

C_cap = 2*CL - C_pin,

Where CL is listed in the crystal datasheet and C_pin is 4pF for the nRF52 series.

The frequency accuracy of the 32MHz crystal directly impacts the frequency accuracy of the radio. If this crystal is loaded incorrectly the radio carrier frequency may be offset to much leading to the advertising packages not being picked up by the receiver.

Best regards,

Bendik

Best

RE: BLE Antenna Issues on Custom nRF52840 PCB – Need Help!

ramprakash72 — Fri, 28 Feb 2025 10:58:44 GMT

I enabled the internal RC oscillator, and the BLE started advertising on one board (Mounted nRF52 components only). However, the other board is still not working. The BLE does not function on the other PCB, even though all components are mounted

How to fix oscillator Issue? Do anyone see Issues with Oscillator placement. Here is part number -

TSX-3225_32.0000MF10Z-W6
ABS06-107-32.768KHZ-T