https://devzone.nordicsemi.com/f/nordic-q-a/119693/nrf54l15-dk-board-segger-firmware-issueHello, I&#39;ve been using nRF54L15-DK devboard (0.9.2 revision on the label) for about a month now without any problems until today. I wanted to change VDD output voltage using Board configurator tool. After that button &#39;write config&#39; is just disableden-USTelligent Community 13Wed, 19 Mar 2025 04:43:57 GMThttps://devzone.nordicsemi.com/thread/527928?ContentTypeID=1Wed, 19 Mar 2025 04:43:57 GMT137ad170-7792-4731-bb38-c0d22fbe4515:fe4406b0-7384-49dc-9c1f-38893b7c31f0lunadam<p>Hard Reset the Board<br />Unplug the board. <span style="color:#ffffff;"><a style="color:#ffffff;" href="https://geometrydashwave.io">Geometry Dash</a></span><br />Press and hold the RESET button on the board.<br />Plug in the USB while holding RESET, then release it after a few seconds.<br />Check if the board appears in nRF Connect or J-Link Commander (JLinkExe on Linux).</p><div style="clear:both;"></div>https://devzone.nordicsemi.com/thread/527038?ContentTypeID=1Wed, 12 Mar 2025 18:21:07 GMT137ad170-7792-4731-bb38-c0d22fbe4515:ae9f8726-4067-4845-ad44-1d7aca0cdaaaAndriiHere<p>I have found the problem. windows somehow automatically changed usb-controller device driver to &#39;USBIP Shared Device&#39;, apparently when I used it with WSL. <br />Reverted drivers back to &#39;USB Composite Device&#39; and now everything works fine.</p><div style="clear:both;"></div>