[ncs 3.2.0/3.2.1] Impossible to debug since ncs 3.2.0

RE: [ncs 3.2.0/3.2.1] Impossible to debug since ncs 3.2.0

JONATHAN LL — Mon, 26 Jan 2026 10:33:13 GMT

Hi Alessandro,
You can try and update but I am not convinced that is the issues as things work fine on previous version. Have you tested with the nRF53L15DK as the debugguer? If this works with no issues then I think its likley an outdated verison for the Jlink ultra.

RE: [ncs 3.2.0/3.2.1] Impossible to debug since ncs 3.2.0

longo92 — Wed, 21 Jan 2026 07:02:00 GMT

I am on custom project.

Effecively on simple led blinky sample on nrf54l15dk under ncs 3.2.1 i am not getting the issue.

I should try to debug using the nrf54l15dk as debug probe.

By the way:

Is it possible that i need to udpate my seggere jlink uktra+ firmware?It seems outdated (2022)...
Which version should i use with ncs 3.2.1? I am using the v8.76

Thanks,

Again

RE: [ncs 3.2.0/3.2.1] Impossible to debug since ncs 3.2.0

JONATHAN LL — Tue, 20 Jan 2026 12:02:39 GMT

Are you using a sample when you try to debug? Or you own custom project. Have you changed some of the compile settings?

Regards,
Jonathan

RE: [ncs 3.2.0/3.2.1] Impossible to debug since ncs 3.2.0

longo92 — Tue, 20 Jan 2026 08:03:44 GMT

i am on j-link v8.76.

I have tried only using VS code.

Maybe is an issue on my setup.

I will try with another board.

RE: [ncs 3.2.0/3.2.1] Impossible to debug since ncs 3.2.0

JONATHAN LL — Tue, 13 Jan 2026 23:24:19 GMT

[quote user=""] (jlink ultra+, under VS code with nrf connect extension)[/quote]

Do you have the same issue if you try to connect with a debugger not with VS code?

Have you tried to update the Jlink driver?

I have not tried to reproduce this as of now.

Regards,
Jonathan