Power Profiler kit ii on nRF54L15

RE: Power Profiler kit ii on nRF54L15

Ressa — Fri, 23 Jan 2026 10:19:23 GMT

For source meter mode, where the supply directly comes from PPKII, you need to connect VOUT (from PPKII) to nRF54 pin (on DK), and also GND pin from PPKII to GND on DK. Then in software you choose Source meter and select the desired voltage and then enable output power.

RE: Power Profiler kit ii on nRF54L15

Ressa — Fri, 23 Jan 2026 10:15:53 GMT

And then in nRF Connect for Desktop, in power profiler section, you choose Ampere meter and then enable output power:

RE: Power Profiler kit ii on nRF54L15

Ressa — Fri, 23 Jan 2026 10:13:17 GMT

Hi,

For connecting in Ampere meter mode, you need to connect PPKII in series when P6 is removed.

From IDD pin(on DK) to VIN (on PPKII) and from VOUT (on PPKII) to nRF54 (on DK).

RE: Power Profiler kit ii on nRF54L15

haan — Fri, 23 Jan 2026 06:33:45 GMT

can i clarify for both source/ampere mode connection, both are connected using red wire Vin to IDD of the board and brown wire Vout to the nRF54 of the board? Also do the black wire has to be connected to the GND of the board?