Can nRF24L01 leave the RX mode with CE tied to VDD?

RE: Can nRF24L01 leave the RX mode with CE tied to VDD?

MCY — Fri, 13 May 2016 07:00:31 GMT

I ran the test and it works - like you said it would most likely do! By the way, I also found on the internet that some people have tied the CE pin to the CSN pin. That would put the unit in standby each time spi is activated. However that would also mean that receiver would be down on each and every spi operation, with an associated delay. So, CE=1 is the way I will go, it allows a better control over device states. Thanks again for the information.

RE: Can nRF24L01 leave the RX mode with CE tied to VDD?

MCY — Thu, 12 May 2016 10:37:46 GMT

Thanks for the answer. I was worried by the statement "Executable in power down or standby modes only" associated with the W_REGISTER command in the specs. If I cannot use this command, I cannot change the PWR_UP bit. What I understand from your answer is that the command may still work, though "not tested and qualified". I guess I will try and see if the operation can be performed consistently with the modules I have. Thanks again..

RE: Can nRF24L01 leave the RX mode with CE tied to VDD?

Kenneth — Thu, 12 May 2016 10:07:57 GMT

Hi, most likely this will work. It's not tested and qualified operation, but it is technically possible to set CE high all the time, and write the PWR_UP bit in the CONFIG register, and change configuration when in power down. There will effectively be a 1.5ms delay when changing configuration when enable PWR_Up bit again, due to the startup of the 16MHz crystal, but likely it will work.