RE: nRF8001 Incomplete Setup

Soren — Wed, 22 Jan 2014 06:49:43 GMT

Hi Runar,

You were right. After sending the last setup packet, I had to generate the SPI clock for not 1 packet but 3 packets (i.e. sent 3 packets of 6 dummy bytes) and then nRF8001 responded back that the setup is complete. I also changed the "Active signal" in nRFgo Studio from active high to active low which I think helped fix my issue.

Thank you for your help, Soren

RE: nRF8001 Incomplete Setup

run_ar — Tue, 21 Jan 2014 11:44:42 GMT

Hi,

In the attachment; if you are sending the last setup packet here, you will get a command response to this once the packet is processed. Please also make sure you set the length byte in the transmit buffer to 0 when you are done transmitting. The interface is asynchronous so the nRF8001 can buffer packets. Make sure you read out all command responses as this will be sent after a command is processed (not when it is received).

Best regards, Runar