nrf51822 oscillator requirement for flashing

RE: nrf51822 oscillator requirement for flashing

RK — Fri, 19 Aug 2016 00:35:38 GMT

It's very hard. I'm using a home made reflow oven and I've got 1 of 3 fully soldered the first time, one of the other two I never got to work and the other one I got working after a lot of messing about with hot air. I actually just ordered a stencil to try and make this a bit easier.

RE: nrf51822 oscillator requirement for flashing

Flagada15 — Thu, 18 Aug 2016 16:49:30 GMT

ok I will try that thank you! solder those ships is harder than I though ;)

RE: nrf51822 oscillator requirement for flashing

RK — Thu, 18 Aug 2016 16:05:25 GMT

adding a blank line so that the formatting works ...

JLink -if swd -device nrf51

connect

try that - that's the most basic

RE: nrf51822 oscillator requirement for flashing

Flagada15 — Thu, 18 Aug 2016 15:35:48 GMT

Thank you very much for your answer, still not making it works but I will find :) It's a good thing that we can test the ship before to solder all the other components ;)

I am using a nrf51-dk via the p20 port to flash the standalone ship, what JLink command you would use in order to test the connexion? On my side, when I try to upload the .hex file I just receive a FAIL.TXT file saying "Error while connecting to CPU"...

RE: nrf51822 oscillator requirement for flashing

RK — Wed, 17 Aug 2016 23:38:01 GMT

You don't need any crystals at all in order to flash the chip. The internal RC oscillator is sufficient. You actually don't need any crystals at all until you need bluetooth or a couple of other bits of hardware which require the HF clock.

You should try some JLink command line commands to confirm basic ability to connect to the board at all. You probably have a soldering problem.