Don't stay in sleep mode after switch off voltage

RE: Don't stay in sleep mode after switch off voltage

butch — Fri, 16 Sep 2016 11:21:57 GMT

If you lose power, known as brownout, the chip should be held in reset so it does not output spurious signals, and the chip is non-functional. When power comes back, known as POR power on reset, it enters the reset ISR and reboots. Do you expect it to be in sleep mode after such a POR? Your reset ISR must do that.

RE: Don't stay in sleep mode after switch off voltage

1_andi — Fri, 16 Sep 2016 09:50:52 GMT

At the moment we are using nrf52 Eng A. So the Errata 11 must be implemented. I have configured PORT event for wakeup. If the nrf52 are flashed and have vcc, the sleep mode are ok. When we loose the vcc, disconnect Accu or exhaust battery, the device don't stay in sleep mode. Is there a register who loose data for it?

RE: Don't stay in sleep mode after switch off voltage

Susheel Nuguru — Wed, 14 Sep 2016 11:38:51 GMT

well it depends on your application isn't it? the SD will detect that there is an application and just jump the control over it upon boot up. Then if the application is going to sleep mode then it is application responsibility to configure a wakeup source. The Errata 11 is only valid for Eng A and if you have configured PORT event for wakeup.

RE: Don't stay in sleep mode after switch off voltage

1_andi — Wed, 14 Sep 2016 11:05:47 GMT

I flashing the SDK 0.9.2 and our own application. I mean this Errata: [11] System: Device is unable to stay in System OFF mode.

RE: Don't stay in sleep mode after switch off voltage

Susheel Nuguru — Wed, 14 Sep 2016 10:55:41 GMT

what are you flashing into your chip? what Errata in Eng A are you talking about?