https://devzone.nordicsemi.com/f/nordic-q-a/17908/program-the-nrf5x-dk-while-using-the-power-profiler-kitI have one of the new Power Profiler Kits, and it works really well (well done!). The only problem is I can&#39;t reprogram the dev kit while it is connected to the Power Profiler. If I try to it says the --family doesn&#39;t match, which I assume is becauseen-USTelligent Community 13Mon, 12 Dec 2016 10:33:30 GMThttps://devzone.nordicsemi.com/thread/69049?ContentTypeID=1Mon, 12 Dec 2016 10:33:30 GMT137ad170-7792-4731-bb38-c0d22fbe4515:fb242d50-41aa-47bd-9ff4-7a44ed4f489cwlgrd<p>Thank you for the answer and the feedback. I will take that proposal with me for the next release!</p><div style="clear:both;"></div>https://devzone.nordicsemi.com/thread/69048?ContentTypeID=1Tue, 22 Nov 2016 12:47:16 GMT137ad170-7792-4731-bb38-c0d22fbe4515:70a79205-6676-4efb-a9d6-7e56fa569cb3Tim<p>Aha I found a relatively simple way.</p> <ol> <li>Turn the nRF5x-DK board off with the toggle switch in the corner.</li> <li>Toggle the tiny slider switch in the middle of the Power Profiler labelled <code>COM</code> to <code>EXT</code>.</li> <li>Turn the nRF5x-DK board back on.</li> <li>Flash the board.</li> </ol> <p>Then you can turn it on/off and switch <code>COM</code> back to <code>DK</code>. Or you can leave it on <code>EXT</code> and connect the Power Profiler via another SWD connector.</p> <p>Would have been nice if the <code>COM</code> switch were a bit bigger, like the power switch on the DK. Maybe something for the next revision?</p><div style="clear:both;"></div>