nRFgo Studio cannot program custom board

RE: nRFgo Studio cannot program custom board

bjorn-spockeli — Thu, 23 Aug 2018 08:30:09 GMT

Hi Andre,

nRFGO Studio is deprecated and does not fully support the new additions to the NRF52 series, e.g. the nRF52810 and the nRF52840. The programming GUI in nRFGo studio will be replaced with a nRF Programmer application in the nRF Connect for Desktop framework. However, this app is still in an experimental state, so meanwhile i recommend that you use nrfjprog from nRF5x Command Line Tools to flash firmware to your devices.

Best regards

Bjørn

RE: nRFgo Studio cannot program custom board

studzinski — Wed, 22 Aug 2018 18:11:08 GMT

I have exactly the same problem. I can flash SD and code with Keil 5 but not with nRFgo studio. So I think the HW connections are good. Where is the problem?

Is any setting tab in nRFgo Studio application? Could not fin such tab. Only Help & View...

I use the nRF52810 chip and cannot compare with a DK (unfortunately there is not any DK for this chip).

RE: nRFgo Studio cannot program custom board

bjorn-spockeli — Tue, 13 Dec 2016 10:38:22 GMT

Are you powering the custom board from the nRF51 DKs VDD? Are you able to program the custom board if you use nrfjprog?