Use signal Active on nRF8001

RE: Use signal Active on nRF8001

Jørn — Wed, 31 May 2017 09:32:58 GMT

How have you generated your setup file? nRFgo Studio is not used to program the 8001 itself, but to generate the setup file which must be relayed to the nRF8001 via your pic24.

RE: Use signal Active on nRF8001

PatDes — Wed, 31 May 2017 09:21:39 GMT

Thank you for your prompt response. The nRF8001 is directly connected to a pic24 (16 bit) peak. I do not use nRfgo studio. I repeat my question. Best regards. PatDes

RE: Use signal Active on nRF8001

Jørn — Wed, 31 May 2017 08:45:40 GMT

Hello PatDes

The Active signal of the nRF8001, and its polarity, is set in the hardware configuration of the Setup commands. When using nRFgo Studio you find it under the tab "Hardware Settings".

Also, do note that the maximum output current from the pins of the nRF8001 should not exceed 0.5 mA, see page 34 of the product specification.

Best regards

Jørn Frøysa