https://devzone.nordicsemi.com/f/nordic-q-a/22896/gpiote-accuracy-and-rtcI&#39;m trying to use a low accuracy GPIOTE event to start RTC1. The following code works as expected when using hi accuracy mode but will constantly trigger in_pin_handler() using low accuracy mode. If I remove nrf_drv_rtc_enable() from in_pin_handler()en-USTelligent Community 13Thu, 29 Jun 2017 10:19:22 GMThttps://devzone.nordicsemi.com/thread/90047?ContentTypeID=1Thu, 29 Jun 2017 10:19:22 GMT137ad170-7792-4731-bb38-c0d22fbe4515:affc6c96-150a-41d2-9115-9d37ac1934cemuon<p>Hi Kristin, thank you for your reply. I&#39;ve tested your example and this works perfectly - my issue was with a pull-down within the device I have connected to the GPIO - which didn&#39;t seem to be an issue with hi accuracy mode.</p><div style="clear:both;"></div>https://devzone.nordicsemi.com/thread/90046?ContentTypeID=1Tue, 20 Jun 2017 12:37:39 GMT137ad170-7792-4731-bb38-c0d22fbe4515:940c4167-b28b-4b48-a19b-c2088b234d1dFormerMember<p>When I test what you describe, <code>in_pin_handler()</code>will not constantly be called. Attached is the project I have used for the testing (SDK 13): <a href="https://devzone.nordicsemi.com/cfs-file/__key/communityserver-discussions-components-files/4/gpiote_5F00_modified.zip">gpiote_modified.zip</a>.</p> <p>Could you test my project and check if you see the same behavior?</p><div style="clear:both;"></div>