Sending receiving UDP Data wit nrf51 Dongle

RE: Sending receiving UDP Data wit nrf51 Dongle

bjorn-spockeli — Wed, 02 Aug 2017 09:06:49 GMT

The Master Emulator SW is deprecated so I strongly advise you to use the pc-ble-driver instead.

RE: Sending receiving UDP Data wit nrf51 Dongle

Kagan — Wed, 02 Aug 2017 09:05:07 GMT

Hi Bjørn,

Thank you for response.

I know about pc-ble-driver. Also is there chance to create custom service with Master Emulator Examples. I know Master Emulator Examples are old but I think this way is faster. I just want test my device. After testing I am planning to use pc-ble-driver.

RE: Sending receiving UDP Data wit nrf51 Dongle

bjorn-spockeli — Wed, 02 Aug 2017 08:58:55 GMT

Hi Kağan,

if you just want to forward the UDP payload to your nRF51822, then you should be able to create a custom service that sends the payload in chunks.

On the computer side you would have to create some kind of application that that parses UDP packets and uses the pc-ble-driver to communicate with the nRF51 Dongle

You could also take a look at our IoT SDK, see this Infocenter page, but note that it only supports the nRF52 Series.

Best regards

Bjørn