Flashing application while Power Kit is on DK

RE: Flashing application while Power Kit is on DK

Sigurd — Tue, 03 Dec 2019 10:28:12 GMT

Felix Link is now fixed.

RE: Flashing application while Power Kit is on DK

Felix — Tue, 03 Dec 2019 02:01:16 GMT

link is dead (like many on this site)

RE: Flashing application while Power Kit is on DK

Mathias — Tue, 08 Aug 2017 10:58:23 GMT

Ok great, thanks :)

RE: Flashing application while Power Kit is on DK

Sigurd — Tue, 08 Aug 2017 10:26:15 GMT

Great you got it working : ) Yes, these types of stickers can be a little tricky to get off. Note that if you later want to remove the PPK, you don't have to solder the SB9-bridge to get the DK back in "normal behavior", you can simple just put a jumper cable or a jumper connector(link1,link2) on the P22 connector(labeled nRF current measurement on the DK)

RE: Flashing application while Power Kit is on DK

Mathias — Tue, 08 Aug 2017 10:03:56 GMT

Nevermind, got it of, nothing blew up and I think it worked. Thanks again! :)

RE: Flashing application while Power Kit is on DK

Mathias — Tue, 08 Aug 2017 09:52:53 GMT

Hi Sigurd!

Thanks for helping :) I found the switch but it appears to be protected by some kind of "sticker" or something. I can't seem to set the switch because of it lying on top of it and it doesn't seem to be a normal sticker because I can't get it of so easily. Is this just some sort of protection or ... ?

RE: Flashing application while Power Kit is on DK

Sigurd — Tue, 08 Aug 2017 09:35:51 GMT

Hi,

If you want to flash firmware to the DK, while the PPK is connect to the DK, you can set the PKK switch COM (SW3) to EXT. This will disconnect the PPK from the SEGGER J-Link on the nRF5x DK. More information can be found on this page.