Problem with connection BLED112 to BMD-300 (sometimes)

RE: Problem with connection BLED112 to BMD-300 (sometimes)

Hung Bui — Thu, 09 Nov 2017 08:56:34 GMT

I don't know how it's implemented, the firmware, on the Bluegiga board, so it's hard to tell.

RE: Problem with connection BLED112 to BMD-300 (sometimes)

marogo — Tue, 07 Nov 2017 22:38:07 GMT

I noticed that the connection problem occurs if I try to connect after a few seconds after the scan finishes. I suppose that one of the devices (BLED112 or BMD-300) goes into standby mode after few seconds, because if I try to connect immediately after stopping the scan, the connection is always established (event "ble_evt_connection_status" is triggered). What do you think about it?

RE: Problem with connection BLED112 to BMD-300 (sometimes)

Hung Bui — Mon, 06 Nov 2017 14:34:49 GMT

Hi Marogo,

I'm not sure people here would have much knowledge on the Bluegiga BLE GUI Tool. Have you tried to send your question to Bluegiga ?

Also, if you can provide a sniffer trace, it could be easier to understand what exactly happened.