how to erase nrf51822 softdevice or app code

RE: how to erase nrf51822 softdevice or app code

yuyixuantai — Mon, 13 Nov 2017 08:30:53 GMT

The problem has resolved. The flash can erase with jlink(V9) with latest dirver.

RE: how to erase nrf51822 softdevice or app code

endnode — Mon, 13 Nov 2017 08:24:18 GMT

Great, so let's close the question and mark the solution!;)

RE: how to erase nrf51822 softdevice or app code

yuyixuantai — Mon, 13 Nov 2017 08:23:11 GMT

The problem have resolved in 11:55 AM with a new jlink(V9) with new driver(V6.20). my old jlink is V8 and driver is V4.98e. I have test several times, now can sure that the Jlink(V8) with V4.98e can download and debug the app-code in general, but if the code cause some problems (erase error flash area, power off so quick, the app-code don't match the device-soft, and so on), the jlink(V8) cannot work.

You are right, Thank you;

RE: how to erase nrf51822 softdevice or app code

endnode — Mon, 13 Nov 2017 07:21:15 GMT

As I say, if you really believe that malfunctioning of JTAG/SWD interface relates to NRF_UART0 register then it indicates rather some electrical problem. Have you tried with different wiring, USB port etc.? Like really revised entire set-up not only changing one wire to another from the same box and claiming "neah, it didn't help"?! What HW do you use? If it would be a problem of nRF51 chip then you could reproduce it on nRF5 DK board. If so then you can use another SEGGER J-Link (or similar SWD compatible) programmer, attach to DEBUG IN port and try to erase the target this way (bypassing internal SEGGER J-Link OB). There are many things you can try and while there might be a failure of the chip or relation to some FW features you have enabled in your code it's so unlikely that I would never claim it unless I tried very hard all other ways!

RE: how to erase nrf51822 softdevice or app code

yuyixuantai — Mon, 13 Nov 2017 02:18:09 GMT

I am sure jlink has no problem, becase it work ok in orther 51822_board. And I write NRF_UART0 in two board, the same problem arise. Although it doesn't seem possible， but I have no board to test " write NRF_UART0".

I want to konw Is there other method to erase 51822, I have test all the method what I know in two PC with two jlink.

RE: how to erase nrf51822 softdevice or app code

endnode — Sat, 11 Nov 2017 09:52:44 GMT

No, writing to NRF_UART0 or other registers cannot brick the device, don't worry. Most probably just your USB cable or other wiring causes errors to JTAG/SWD line. Try different USB port, different PC, different (shorter and thicker/better) USB cable, unplug all jump-wires and other connectors from the target...