Eddystone beacon using nrf51822/waveshare ble400 and blackmagic probe in Arduino IDE

RE: Eddystone beacon using nrf51822/waveshare ble400 and blackmagic probe in Arduino IDE

nar0909 — Fri, 15 Dec 2017 04:32:35 GMT

Also what is your nRF51822 dev version number? If your BMP does not have your version number then you have to request the Blackmagic probe GitHub repo to include your version into the firmware and flash the new firmware binary into your BMP device. github.com/.../blackmagic.git Please find the below link on whether BMP supports ur version github.com/.../nrf51.c

I have added the above device into the blackmagic repo by pulling a request to add. Do the same, but make sure you confirm with Nordic Semiconductor first about the version number and send BMP guys the confirmation link or else your device will not be added. Thanks

RE: Eddystone beacon using nrf51822/waveshare ble400 and blackmagic probe in Arduino IDE

nar0909 — Fri, 15 Dec 2017 04:25:44 GMT

www.youtube.com/.../UCZkTQArthLzGpNaj6YdImIA Use the above tutorial as a reference and I have used the same and it gives you a clear idea on how to get it to work.

RE: Eddystone beacon using nrf51822/waveshare ble400 and blackmagic probe in Arduino IDE

Bjørn Kvaale — Mon, 20 Nov 2017 08:21:57 GMT

Have you taken a look at this devzone case yet? Which blackmagic probe are you currently using (i.e. v1.0, v2.1., etc)?