[bluetooth mesh] Pb Remote combine light switch control

RE: [bluetooth mesh] Pb Remote combine light switch control

Duy — Sun, 20 Sep 2020 04:52:59 GMT

Hi alexa,

Sorry was too busy. If you like, I can share you my preconfigured examples. Just drop an email to lowe.tran@gmail.com then I can send it to you.

RE: [bluetooth mesh] Pb Remote combine light switch control

alexa — Fri, 28 Aug 2020 08:49:56 GMT

Hello! Have you found the time to share this issue & possible solution? 🙂

RE: [bluetooth mesh] Pb Remote combine light switch control

Duy — Tue, 14 May 2019 14:09:36 GMT

I am going to share a blog post about this soon.

RE: [bluetooth mesh] Pb Remote combine light switch control

Duy — Tue, 14 May 2019 14:08:00 GMT

Hi Hung Bui, sorry for the late reply, but I did it.

RE: [bluetooth mesh] Pb Remote combine light switch control

Gaurav — Thu, 21 Dec 2017 05:33:52 GMT

Hi! Duy, Have you succeeded finally? I am also stuck on the client side while doing it.

RE: [bluetooth mesh] Pb Remote combine light switch control

Hung Bui — Tue, 05 Dec 2017 00:28:47 GMT

Have you tried to step into the code as I suggested above ?

RE: [bluetooth mesh] Pb Remote combine light switch control

Duy — Sun, 03 Dec 2017 15:29:10 GMT

Hi Hung,

Thank you for your answer. I am still finding the way to solve error code 4 as I only use 2 - 3 servers. Thanks again for your help.

RE: [bluetooth mesh] Pb Remote combine light switch control

Hung Bui — Fri, 24 Nov 2017 11:27:38 GMT

Hi Duy,

Again, when you see a error and find where it occurs, you can set a break point at the line that cause the error and step in to the code (use the assembly stepping on the left hand side) . For example the line cause error code 4 (NO_MEM) you step into that you can find that it was caused by access_model_add() and inside that more likely the call to find_available_model() returned (ACCESS_HANDLE_INVALID == *p_model_handle) and then return NO_MEM. And if you step into find_available_model() you can find that it was because there isn't any access model slot yet to allocate. Then it comes to ACCESS_MODEL_COUNT define, if you add more client, server you need to increase this to match with the number of model on your device.

Error code 7 is NRF_ERROR_INVALID_PARAM (check nrf_error.h), and you can find that inside access_model_publish_address_set() there is a check if (DSM_ADDR_MAX <= address_handle) most likely the address_handle is over the DSM_ADDR_MAX.