what code i have to write in Segger Embedded Studio to disable the attach to a running target on my board?

RE: what code i have to write in Segger Embedded Studio to disable the attach to a running target on my board?

Joakim Jakobsen — Thu, 18 Jan 2018 09:58:30 GMT

No problem! Happy to help :)

RE: what code i have to write in Segger Embedded Studio to disable the attach to a running target on my board?

AMER — Mon, 15 Jan 2018 08:29:25 GMT

thank you :)...

RE: what code i have to write in Segger Embedded Studio to disable the attach to a running target on my board?

Joakim Jakobsen — Thu, 04 Jan 2018 11:46:35 GMT

Hi AMER.

I guess what you want is to enable the readback protection.

I don't know of any way to do this in SEGGER Embedded Studio other than add it to your code.
That means writing to the UICR, more specific the APPROTECT register.
Take a look at this answer.

Another way to enable readback protection, is using nrfjprog.
You can use the command; nrfjprog --rbp ALL
You can also enable the readback protection in nRFgo Studio.

Hope that helps. Let me know if you have any more questions.
Best regards,
Joakim.

RE: what code i have to write in Segger Embedded Studio to disable the attach to a running target on my board?

AMER — Thu, 04 Jan 2018 10:28:36 GMT

i flashed a program on a sensor and I don't want anyone steal my program from my sensor. I want to disable reading from the sensor that I flashed.

RE: what code i have to write in Segger Embedded Studio to disable the attach to a running target on my board?

Joakim Jakobsen — Thu, 04 Jan 2018 09:59:44 GMT

Hi AMER!
Could you elaborate a little around what you are trying to do?
I'm not quite sure what you want to acheive.
Best regards.