Using nRF52832 P0.9 problems as output

RE: Using nRF52832 P0.9 problems as output

Simonr — Mon, 06 Jan 2025 12:22:46 GMT

Sorry about the late reply, it's been holiday season in Norway, so we've been very low on staff the last few weeks.

This has been asked and answered multiple times for the nRF Connect SDK as well.

As of NCS v2.5.0, you need to use the devicetree to configure NFCT pins as GPIOS like this: &uicr { nfct-pins-as-gpios; }; in your project's .dts file.

Best regards,

Simon

RE: Using nRF52832 P0.9 problems as output

LC2047 — Tue, 24 Dec 2024 02:36:34 GMT

I have same problem too. Could you share your solution with me?

I don't have NFC function in my project and it is custome board(not DK). Is it necessary to create new board in VS code?

RE: Using nRF52832 P0.9 problems as output

AmbystomaLabs — Fri, 19 Jan 2018 21:59:42 GMT

Per the spec, p0.9 and p0.10 are NFC by default. Special consideration must be taken in software and hardware on the DK to use these as gpio.

infocenter.nordicsemi.com/index.jsp

devzone.nordicsemi.com/.../