Send a packet with RedBearLab Blend Micro and nRF8001 using BLE advertising

RE: Send a packet with RedBearLab Blend Micro and nRF8001 using BLE advertising

Ander GB — Tue, 27 Feb 2018 09:35:37 GMT

This works just fine. Thank you very much!

RE: Send a packet with RedBearLab Blend Micro and nRF8001 using BLE advertising

David Edwin — Thu, 22 Feb 2018 16:53:10 GMT

Ok. Edit the XML file using nRFgo studio in GAP Setting -> ACI broadcast

Switch off the local name (do not advertise) , local services in the check boxes and anything else that is checked on.

Check on "Custom 1"

On the left side of the page under "Custom advertisement types" put 0xFF for Manufacturer specific data and the 0x59000005FFF703FB56 that you want.

I have a sample attached for you to take a look.devzone.nordicsemi.com/.../ble_5F00_broadcast_5F00_mauf_5F00_specific.xml

RE: Send a packet with RedBearLab Blend Micro and nRF8001 using BLE advertising

Ander GB — Thu, 08 Feb 2018 16:00:44 GMT

According to the nRF connect app, the ble_broadcast example sends this:

0x01 (Flags) 0x06
0x09 (Complete Local Name) 0x426C656E644D6963726F
0X07 (Complete List of 128-bit Service Class UUIDs)1E948DF1483194BA754C3E5000003D71
0x09 (Complete Local Name) 0x426C656E644D6963726F

It doesn't matter if I change the services.h file, it always sends that. I would like to send this:

0x01 (Flags) 0x06
0xFF (Manufacturer Specific Data) 0x59000005FFF703FB56

Because is what the nRF52832 chip that I have in the application that I want to mimic is sending. but I have read somewhere that it is not possible to change the setup data while advertising, so I just want someway to send the data (59000005FFF703FB56).

RE: Send a packet with RedBearLab Blend Micro and nRF8001 using BLE advertising

David Edwin — Thu, 08 Feb 2018 13:37:07 GMT

Can you use the ble_broadcast example in the ble_sdk_arduino for the nRF8001. This ACI broadcast command is used to send the broadcast the message.