RE: Embedded studio does not run code

secondbest — Tue, 04 Dec 2018 13:17:28 GMT

I have the same problem. The sample example is here. (https://github.com/srcnert/NRF51_Template_Segger_Keil_GCC)

When the code is downloaded from segger embedded studio, the code is stop at "SOFTDEVICE_HANDLER_INIT(&clock_lf_cfg, NULL);". After the reset, there is no problem. Also, when i start the code with debug, there is also no problem.

Can you give any advice about this problem? How can I get the code to automatically run the code without hard resetting the board?

Also, i ask same questions in these posts. But Nobody give the solution.

https://forum.segger.com/index.php/Thread/5771-Segger-Embedded-Studio-project-does-not-run-code-without-press-reset-button/

https://devzone.nordicsemi.com/f/nordic-q-a/40349/segger-embedded-studio-project-does-not-run-code-without-press-reset-button

Thanks.

RE: Embedded studio does not run code

Hung Bui — Mon, 26 Mar 2018 13:58:24 GMT

Hi Anthony,

Could you send your project here so we can test ?

Have you tried to test with very simple program such as blinking an LED to see if it works ? We have seen project hang right after programming if RTT Viewer is connected to the board before flashing.