nRFL24LE1, nRF24L01+ interoperability

RE: nRFL24LE1, nRF24L01+ interoperability

mr_creosote — Fri, 16 Dec 2016 15:44:17 GMT

Thank you!

RE: nRFL24LE1, nRF24L01+ interoperability

Kenneth — Wed, 14 Dec 2016 12:39:13 GMT

Hi,

With the minimum configuration yes, as the dynamic payload length feature is not enabled by default.

Best regards,

Kenneth

RE: nRFL24LE1, nRF24L01+ interoperability

mr_creosote — Wed, 14 Dec 2016 12:31:39 GMT

Hi, does the payload width need to be set on the RX end as well? Thanks, Mahesh

RE: nRFL24LE1, nRF24L01+ interoperability

Kenneth — Wed, 14 Dec 2016 11:35:09 GMT

Hi Mahesh,

In cases like these I always recommend to go for the minimum configuration to achieve communication, and then work from there.

- The minimum configuration on a PRX is to set the operation mode to RX and the rx payload width of pipe0 to specific length (e.g. 3), then write PWR_UP bit to 1 (wait ~2ms), and set CE to 1.

- The minimum configuration on a PTX is write PWR_UP bit to 1 (wait ~2ms), then write the TX payload with a specific length (e.g. 3), and toggle CE to start transmission.

I do notice in your case it seems that data rate is different between LE1 and L01, but in any case good to start with the minimum configuration.

Best regards,

Kenneth