Mesh Relay

RE: Mesh Relay

Nakul Nair — Sun, 17 Jun 2018 16:57:37 GMT

Is it neccessary to use BLE+Mesh because in my application I only need to scan and not initiate a connection

RE: Mesh Relay

Bjørn Kvaale — Wed, 16 May 2018 14:36:03 GMT

If the furthest devices to be provisioned in the mesh network are out of range of the provisioner & you do not want to move the provisioner around to provision all of the devices in the mesh network, it could be a good idea to use the remote provisioning example. To print the data from the provisioner, you can either use an RTT viewer on your computer connected to the provisioner via usb or you can take a look at combining the provisioner example with uart (similar to this case). It is probably a better idea to take a look at this link first though & try this.

RE: Mesh Relay

Nakul Nair — Wed, 16 May 2018 08:10:04 GMT

So if I have to scan for beacons and relay the info of beacons across a mesh..so as mentioned above do I need to use the remote provisioning example and how to use NUS to print the data which is received in provisioner.

RE: Mesh Relay

arunbm123 — Wed, 04 Apr 2018 16:19:12 GMT

ok...how do I send data from Mesh to wifi...

RE: Mesh Relay

Bjørn Kvaale — Wed, 04 Apr 2018 14:24:17 GMT

You can modify the tx output power to test in a single room (see link).

RE: Mesh Relay

Bjørn Kvaale — Wed, 04 Apr 2018 14:23:15 GMT

I am not sure how to provision a raspberry pi, as I only work with Nordic Semiconductor products unfortunately. So I will not be able to help much with this problem unfortunately. This link might be helpful for you.

RE: Mesh Relay

arunbm123 — Wed, 04 Apr 2018 01:05:26 GMT

Can I reduce the bluetooth Range for testing Mesh Network in single room.

Whats happing is I have to keep the Development Kits far away while testing mesh

RE: Mesh Relay

arunbm123 — Wed, 04 Apr 2018 01:03:53 GMT

hi,

I want to use Raspberry for BlWifi gateway.

As I understand, provisioner allocates address to nodes at time of provision Do I need to provision Pi also. How do I set destination Of Packets to raspberry

RE: Mesh Relay

Bjørn Kvaale — Tue, 03 Apr 2018 16:27:10 GMT

1) There is a remote provisioning example in the mesh sdk, which allows you to provision a device that is not in radio contact with the provisioner via the Mesh network.

2) Should be possible

3) Should be possible to provision a gateway, although you would need to write the code yourself, as there is currently no example code for a mesh gateway.