Ant+ connection is too close

RE: Ant+ connection is too close

Kenneth — Wed, 16 May 2018 14:09:58 GMT

Not sure what is the best way to proceed here. We are not aware of any issues that may explain what you experience. It may be that you have received a Devkit that is not working as intended, it may be there is much interference in the environment, it may be that you need to try another SDK example for test, it may also be the Garmin EDGE 1000. To debug further you will need more hardware to test with and try to repeat the test in a different controlled (chamber) environment.

Best regards,
Kenneth

RE: Ant+ connection is too close

burton.yin — Wed, 16 May 2018 01:28:52 GMT

We only have "Garmin's EDGE 1000" here, and our development board "PCA10040" is officially provided, and on this development board, Bluetooth is working properly and the ant+ protocol stack is at "">https://www.thisisant.com" /developer/components/"Download;
"Garmin's EDGE 1000" is connected to a Garmin power meter, the work is ok, and it is in the same room

RE: Ant+ connection is too close

Kenneth — Tue, 15 May 2018 13:17:59 GMT

Hi,

Do you see this only using "Garmin EDGE 1000", or do you see this also using other ANT+ enabled devices with the PCA10040?

Do you have other Nordic ANT+ enabled products you can use with the "Garmin EDGE 1000" for comparison, as listed here:
https://www.thisisant.com/developer/components/

Is it the same if you do the test in a different room?

Best regards,
Kenneth