RE: NRF52832 Antenna Design

iliescumihai — Sun, 10 Jun 2018 17:12:35 GMT

Thanks a bunch! Your answer was very helpful!

RE: NRF52832 Antenna Design

AmbystomaLabs — Fri, 08 Jun 2018 18:36:34 GMT

There is no simple answer on any of this. All antennas require matching to operate on the intended board. Only if you literally copy precisely a design can you expect to reuse a reference design match. So, if you change absolutely anything at all you can assume you will have to rematch your antenna.

Matching requires a VNA and someone who knows how to use it.

In the schematic above, L1 and C3 match the nRF to 50 ohms. They are predictable as long as you follow the reference layout artwork. Anything on the antenna side will be different for your board. Most .062" 2 layer boards do not have 50ohm traces simply because they are too wide to work with. This makes your work more difficult as changing the electrical length of the nRF to antenna connection affects the match considerably.

In the schematic above, the Johanson is spec'd to have a 9.5dB return loss without a match assuming you follow their ground plane guidelines. A 2.2pF and 3.9nH very nearly form a series bandpass filter at 2.4GHz and with the electrical length from the pads for L5 probably does so reasonably well. Likely these values were chosen not for matching but rather for harmonic suppression.