smart remote add on dk

RE: smart remote add on dk

Jørgen Holmefjord — Fri, 22 Jun 2018 14:58:36 GMT

I don't know if it have been tested with Ubuntu 17.xx, but it should probably work fine. No guarantees though, as the documentation say 16.04 LTS. You will just have to try it out.

RE: smart remote add on dk

pksk — Thu, 21 Jun 2018 05:59:06 GMT

Hi,

Will it work on Ubuntu 17 version? or only on Ubuntu 16.04?

RE: smart remote add on dk

Jørgen Holmefjord — Wed, 20 Jun 2018 13:16:44 GMT

Unfortunately, Windows is not supported by the driver used for the audio service. Linux is typically more used for remote controlled devices than windows.

RE: smart remote add on dk

Jørgen Holmefjord — Wed, 20 Jun 2018 13:15:16 GMT

Same procedure, remove batteries, hold button, put batteries back in while holding button.

RE: smart remote add on dk

pksk — Wed, 20 Jun 2018 12:36:13 GMT

Hi,

Also i am using ready product example , how should i delete the previous bonding information and make it advertise again.

document says press the button during power on but that applies to ad on dk, not with ready product example .

please confirm.

RE: smart remote add on dk

pksk — Wed, 20 Jun 2018 12:28:39 GMT

Hi ,

Thank you why audio configuration is only on Ubuntu why not on windows.

cheers

RE: smart remote add on dk

Jørgen Holmefjord — Wed, 20 Jun 2018 12:26:01 GMT

Hi,

If you have paired (bonded) the smart remote with a device, it will do directed advertising towards this device and go to sleep after a short period of time. You can delete bonding information as desctibed in the Pairing Quick Start documentation.

In order to program the DK add-on board, you need to assemble it as described in the two first sections of the Quick start docuemntation. The firmwares are available for download on the product page. The firmware package contains projects for Keil IDE and GCC compiler.

Best regards,
Jørgen