https://devzone.nordicsemi.com/f/nordic-q-a/3582/nrf24le1-problemsI use two nRF24LE1s as transmiter and receiver ,Here is my question: 1、I set the transmiter side to auto reply mode using PIPE0 ,but i found the STATUS regesitor to be 0b0001 1110 when the receiver side doesn&#39;t work,this can be not correct? 2、I detecten-USTelligent Community 13Wed, 03 Sep 2014 10:30:30 GMThttps://devzone.nordicsemi.com/thread/12980?ContentTypeID=1Wed, 03 Sep 2014 10:30:30 GMT137ad170-7792-4731-bb38-c0d22fbe4515:bd3cab76-298f-45dc-bb92-9261d3ccd086Asbj&#248;rn<p>Do you use the same settings on both PRX and PTX? The value of the STATUS register on the PTX and the pulse on the ANT1 pin indicate that the PTX is sending and reaching the Auto-Retransmit Count goes to maximum and that no packages are received/ACKed.</p> <ul> <li>I would make sure that the RX address and value width is set to the same length and value as TX_ADDR is set to on the PTX.</li> <li>I would enable dynamic payload length on bot PTX and PRX to make sure that it can handle various package lengths. Make sure that the same RF channel is set on both PTX and PRX.</li> </ul> <p>If none of the above works, please submit the entire PRX and PTX configurations here.</p><div style="clear:both;"></div>