RE: SAADC output values on UART

kanika1008 — Thu, 05 Jul 2018 13:51:08 GMT

Hi Kenneth,

Yes I am connected to the right pin. I am using the nRF52 DK.

I also tried to use the example you suggested. I have the same issue there: I see nothing printed out. I am using the Seggar JLink for debugging. What I am seeing is that all NRF_LOG commands are not being written while Seggar_Write commands do write. So I checked the sdk_config.h. In there I tried to enable ( 0-->1) the following:

NRFX_SAADC_CONFIG_LOG_ENABLED 1

NRFX_UARTE_CONFIG_LOG_ENABLED 1

NRFX_UART_CONFIG_LOG_ENABLED 1

However, I see no change and do see anything on the real time debugger......

RE: SAADC output values on UART

Kenneth — Thu, 05 Jul 2018 12:27:54 GMT

Hi,

AIN0 refer to P0.02, are you sure you have connect correct pin?

Have you tried the nRF5 SDK example instead:
http://infocenter.nordicsemi.com/topic/com.nordic.infocenter.sdk5.v15.0.0/nrf_dev_saadc_example.html?cp=4_0_0_4_5_33

Best regards,
Kenneth