Disable the MCU interface on PIN 5, 6, 7, 8 and connect external UART of arm based board

RE: Disable the MCU interface on PIN 5, 6, 7, 8 and connect external UART of arm based board

awneil — Thu, 02 Aug 2018 14:18:01 GMT

[quote userid="72849" url="~/f/nordic-q-a/36975/disable-the-mcu-interface-on-pin-5-6-7-8-and-connect-external-uart-of-arm-based-board/142647"][/quote]

not able to receive data from nRF52832 to the arm processor?

So think about why that might be:

Is the nRF52832 actually sending anything?
IF it is, is it actually reaching your other processor?
If it is, is your receive code on the other processor working?

This is basic debugging.

www.avrfreaks.net/.../2418156

RE: Disable the MCU interface on PIN 5, 6, 7, 8 and connect external UART of arm based board

pin2 — Thu, 02 Aug 2018 14:04:53 GMT

I removed the supply of MCU from SB29 and connected external UART of arm processor as below

(nRF - Arm)

P0.05 - CTS

P0.06 - Rx

P0.07 - RTS

P0.08 - Tx

GND - GND

Using ble_app_uart able to send data from the arm processor to nRF52832, but not able to receive data from nRF52832 to the arm processor?

Are there any changes required in UART driver or sdk_config.h?

Thanks,

Pintu

RE: Disable the MCU interface on PIN 5, 6, 7, 8 and connect external UART of arm based board

awneil — Wed, 01 Aug 2018 07:24:49 GMT

Did you look at the schematic?

Sheet 2 - titled "Interface MCU" - shows you the connections to the interface MCU:

When I view this case, there's a number of "Related" cases listed on the right-hand side.

Have you looked at them?

RE: Disable the MCU interface on PIN 5, 6, 7, 8 and connect external UART of arm based board

pin2 — Wed, 01 Aug 2018 07:11:15 GMT

I am using nRF52832 with SDK 15, I connected GPIO ping 6, 8 with external UART

RE: Disable the MCU interface on PIN 5, 6, 7, 8 and connect external UART of arm based board

awneil — Mon, 30 Jul 2018 11:10:00 GMT

What board are you talking about?

Have you looked at the schematic for that board? That will show you exactly what those solder bridge do!

The nRF52 - like any other system - neither knows nor cares what is connected to its UART. So long as it receives the correct signals, in the correct format, it will be happy.