Program the pca10059 with pca10056

RE: Program the pca10059 with pca10056

Cy — Tue, 11 Sep 2018 16:34:26 GMT

I have tried another dongle with only the SWDCLK and SWDIO hardware edits, the original board also has a piggyback of a voltage regulator and an inertial sensor. I attempted to program the ble_app_blinky example from the SDK15 onto the second dongle with success. I suspect the piggyback is affecting the programming of the original dongle.

RE: Program the pca10059 with pca10056

Cy — Tue, 11 Sep 2018 14:18:01 GMT

Thank you, but your first example is not possible with the hardware as I have described. I have taken over the USB port as the programming port SWDIO is D- and the SWDCLK is D+, though the D- and D+ have been cut from the nRF52840. The USB port is no longer available. Therefore, I want to program it as if it were custom hardware with the DK's and utilize the example project that utilize the pca10056. The board file needs some editing as it is not a pca10056 board, but both boards utilize the nRF52840.

RE: Program the pca10059 with pca10056

AndreasF — Tue, 11 Sep 2018 05:19:56 GMT

Hi.

For your first question I will refer to an answear which was given to a similar question previously asked this month.

The following application examples are available for the pca10059 (nRF52840 USB Dongle):

examples/peripheral/cli, examples/peripheral/blinky, examples/dfu/open_bootloader, examples/connectivity/ble_connectivity, examples/ble_peripheral/ble_app_hrs, examples/ble_peripheral/ble_app_blinky.

That question can be found here.

For your second question, if you want a log file you can look at a guide found on Seggers website here.

Hope this helps.

- Andreas

RE: Program the pca10059 with pca10056

Cy — Mon, 10 Sep 2018 22:54:30 GMT

I have also shorted the SWDIO and the SWDCLK pins to the appropriate USB pad.