Cant figure out steps to certify BLE module with NRF51822, info incomplete.

RE: Cant figure out steps to certify BLE module with NRF51822, info incomplete.

ketiljo — Thu, 04 Oct 2018 13:52:17 GMT

Yep, that seems correct. You don't need a profile subsystem for the Nordic UART service.

RE: Cant figure out steps to certify BLE module with NRF51822, info incomplete.

Alex — Thu, 27 Sep 2018 13:55:04 GMT

Thank you very much for detailed information and help, that does spill more clarity on this matter for me: I do have a follow up question though:

We only use Nordic UART service so this is how I sun it up, please correct if wrong and there is also a question below:

1. We will need PHY QDID from BLE module manufacturer - CHECK

2. For Link and Host layers there is one QDID to be used and in order to determine which one I first need to determine which IC revision we have using this matrix

Then after determined that we will use this matrix to determine proper QDID

3. Now we need to determine which QDID to use for profile, and that is where I have follow up question: I used the search as you suggested and 8 listings have been returned by search, illustration below.

We only use Nordic UART in our code, used SDK v12, Soft Device 130, chip is nRF51822, do we need any of these QDIDs at all? I mostly asking because I simply do not know not can fully understand profile QDID is so I am hoping you can just point to specific one I can use?

4. And then it seems after these QDIDs have been determined that is all it take to get listed in SIG and have approval to go to market?

Thanks again.

RE: Cant figure out steps to certify BLE module with NRF51822, info incomplete.

ketiljo — Thu, 27 Sep 2018 08:35:02 GMT

You can find the QDID's for the nRF51 series in the infocenter.

The separate components, link and host layers, you refer to are outdated, so you must refer to one of the the qualified designs you find in the link above.

You'll combine this with the RF-PHY QDID from Taiyo Yuden for this specific module.

For the profile QDID, go to https://launchstudio.bluetooth.com/listings/search, clock advanced search and fill out "Nordic Semiconductor" as the Company and "Profile Subsystem" in the Product Type.

We do not have an official document for the Profile subsystem, but here is a list i made:

Most services in our SDK are qualified as part of our profile subsystem. You can see the qualified services by looking at the end product listing:

44613

HID Service

HID over GATT Profile

45222

Health Thermometer Profile/Service

Device Information Service (use the newer version)

Immediate Alert Service

Link Loss Service

Proximity Profile

Tx Power Service

Heart Rate Profile (Sensor)

Blood Pressure Profile/service

Battery Service (use the newer version)

Running Speed and Cadence Profile/Service

49943

Device Information Service

Alert Notification Profile

Battery Service

Glucose Profile/Service

Cycling Speed and Cadence Profile/Service

60576

Heart Rate Profile (collector)

70915

Time Profile

You can combine components from the different profile subsystem QDID's. The service interfaces is the same across SDK versions, so not depending on the SDK version. If we change the service interface we will re-qualify it (if the change require re-qualification that is), this means you should use the latest id for services listed in multiple subsystem (battery and Device information service). For SDK 10 BAS is listed in 49943.

I hope this clarifies things.