Application on NRF52DK draws extremely high current after installing the Power profiler kit hard and software.

RE: Application on NRF52DK draws extremely high current after installing the Power profiler kit hard and software.

Bjørn Kvaale — Thu, 22 Nov 2018 13:54:36 GMT

Great! Thank you for the update! 🙂

RE: Application on NRF52DK draws extremely high current after installing the Power profiler kit hard and software.

Huub — Mon, 19 Nov 2018 17:30:52 GMT

Hi Björn,

No problem, I found the error in the mean time. SB9 was not well cut and spoiled all the measurements.

Doing fine now, thanks a lot, greetings, Huub

RE: Application on NRF52DK draws extremely high current after installing the Power profiler kit hard and software.

Bjørn Kvaale — Mon, 19 Nov 2018 13:50:47 GMT

Hi Huub,

Very sorry for the delayed response. I have been travelling on business the last few days & have unfortunately not had time to reply to this DevZone case. Regarding your case:

How do you verify the current draw of 8mA without using the ppk? What kind of instrument are you using? And maybe a weird question: Are you absolutely sure about 8mA, or is it 80mA?

RE: Application on NRF52DK draws extremely high current after installing the Power profiler kit hard and software.

Huub — Tue, 13 Nov 2018 10:33:32 GMT

Hallo Björn,

Yes I use 52832 DK with SB9 cutted.

ble_app_pwr_profiling draws 1,5 uA during advertising.

RE: Application on NRF52DK draws extremely high current after installing the Power profiler kit hard and software.

Bjørn Kvaale — Tue, 13 Nov 2018 09:22:23 GMT

Hi Huub,

You are using a 52832 DK, correct? And you cut the solder bridge SB9? Have you tested with a regular Nordic SDK BLE example? What kind of current values are you receiving then?

RE: Application on NRF52DK draws extremely high current after installing the Power profiler kit hard and software.

Huub — Mon, 12 Nov 2018 16:08:01 GMT

Dear Björn,

Yes switches were according example and I followed the steps.

After measuring the high current (8 mA)with the PPK, I tried a new fresh dev kit without the PPK and also saw the high current. ( measured over 10 Ohm).

So I do not expect I loaded something wrong to the Dev kit.

I compared my source code main.c and config.h in the situation before I connected the PPK (low current 2uA measured over 10 Ohm) and afterwards: no difference.

I installed Segger embedded studio on another computer, compiled and tested. Still the 8 mA high current.

In other words I am unable to revert to the situation (before I installed and connected the PPK) with a current draw of 2 uA.

The whole application (apart from the high 8mA current) runs fine, including sensor readings, computations and BLE.

Where can be the difference???

Thanks in advance, regards,

Huub.

RE: Application on NRF52DK draws extremely high current after installing the Power profiler kit hard and software.

Bjørn Kvaale — Mon, 12 Nov 2018 12:12:54 GMT

Did you flash the PPK hex file to the dev kit instead of the PPK by accident? Were the switches set like in the figure below? Did you follow all of the steps in the quick start guide here?